Q5019
I need an option that is the opposite of -bpa, that is, a listing of those addresses generated from a top-level address that have not yet been delivered.
Exim does not keep this information. It saves only the top-level
addresses and the list of addresses that are finished with. At each
delivery attempt, generated addresses are recomputed from scratch. This
makes it possible to correct errors in redirection data that is causing
delivery delays. However, there is an option you can set on a redirect
router that changes things. It is called one_time, and if it is set,
the list of generated addresses gets added to the top-level list at the
first delivery attempt, and is never regenerated. Because top-level
address lists must be real email addresses, this option cannot be used
if any of the generated addresses are pipes, files, or autoreplies.
- How can I arrange to allow a limited set of users to perform a limited
- I want to tail the Exim log, but I have a number of other logs I also want to tail , and the number of tailing windows is getting to be a nuisance.
- How can I persuade Exim to accept ETRN commands without the leading #
- I've recently noticed that emails I send with a Bcc: line are being
- I used gv 3.5.8 (ghostview) to try printing spec.ps. After every printed page, the printer ejects a blank sheet. Is this something to do with using letter > rather than A4 paper?
- Why aren't there any man pages for Exim? I don't always carry my printed
- When I send a message using the -t command line option, Exim sends
- If I set up a domain list to contain *customer.com, it
- I want to match all domains of the form *.oyoy.org but want a few
- I can't seem to find a pre-built version of Exim anywhere. The machine
- Is there a version of Exim available that runs under Windows?
- Does Exim support Delivery Status Notification (DSN), Message Status
- What does Exim > stand for?
- Although I haven't set
check_spool_space, Exim is still checking the - I just noticed log entries that start off
<= <>. Am I correct in assuming that the<>indicates that the envelope did not contain any From > data? - I've received a message which does not have my address in the To:
- Can (or will) Exim ever handle a message delivery purely in memory, that
- If I am using dbm files for data that Exim reads, can I rebuild them on
- I need an option that is the opposite of -bpa, that is, a listing of
- How can I make Exim receive incoming mail, queue it, but not attempt to
- Does Exim support POP and/or IMAP, or do I have to install something
- Is there an easy way of removing all queued messages at once in a safe
- Why does Exim do ident callbacks by default? Isn't this just a waste
- I often have the problem that a message gets stuck in the mail queue and
- What precautions should I take when editing Exim's run time
- Is exim able to use RFC 2645, On-demand Mail Relay (ODMR)?
- Is there any way I can send bounces to the postmaster, and nobody else?
- When I HUP the Exim daemon, the name shown in the process table changes
- A message with a recipient address that contains a non-printing
- I am using exim in a two queues scenario, with two different
- Why is there no sender address on bounce messages? It shows up as
- Are there any Exim web-based administration scripts?
- How can I send a copy of all outgoing messages to another mailbox?
- Is there any way to make the
queue_onlyoption conditional? I would - Does Exim run with different permissions between -bt and -bh, or
- Can I make Exim stop accepting inbound emails when the queue gets above